Ford 2004 F-150 v.1 Manuel d'utilisateur télécharger pdf (Page 86)

The UNLOCK feature will work again after:

• a door has become ajar,

• the ignition is turned to the ON position, or

• using the UNLOCK

control on your remote entry transmitter or

unlocking via the keyless entry keypad.

Deactivating/activating power door lock disable feature

You must complete Steps 1–5 within 30 seconds, or the procedure will

have to be repeated. If the procedure needs to be repeated, you must

wait a minimum of 30 seconds to begin again.

1. Turn the ignition to the ON position, then press the UNLOCK button

three times.

2. Turn the ignition to the OFF position, then press the UNLOCK button

three times.

3. Turn the ignition to the ON position, and within five seconds, press

the LOCK button two times. Two horn chirps should be heard, indicating

that the system has been disabled. Conversely, two horn chirps followed

by a honk will indicate that the system is enabled.

4. Pressing the power door LOCK button two times again will turn the

feature ON if it was previously OFF, or OFF if it was previously ON.

Every two consecutive presses of the LOCK button after successfully

entering the configuration mode will change the enable/disable condition

of the feature.

5. Turn the ignition to the OFF position to exit programming.

Sounding a panic alarm

Press

to activate the alarm. Press again or turn the ignition to ACC

or ON to deactivate.

Note: The panic alarm will only operate when the ignition is in the OFF

position.

Memory feature (if equipped)

The remote entry system can also control the memory feature.

Press the

control once to unlock the driver’s door. Pressing the

control will automatically move the seat and adjustable pedals to the

desired memory position (the memory position corresponds to the

transmitter being used).

Locks and Security

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 154 155

Pas de commentaire

Ford 2004 F-150 v.1 Manuel d'utilisateur Page 86