Ford 2004 E-450 v.3 Manuel d'utilisateur télécharger pdf (Page 77)

Sounding a panic alarm

Press

to activate the alarm. Press the control again, or turn the

ignition to the 1 (ACCESSORY) or 4 (ON) position to deactivate the

alarm.

Note: The panic alarm will only operate when the ignition is in the 2

(LOCK) or 3 (OFF) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE RUBBER COVER

AND CIRCUIT BOARD OFF THE

FRONT HOUSING OF THE

REMOTE ENTRY TRANSMITTER.

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry

transmitter for the correct orientation of the battery. Press the battery

down to ensure that the battery is fully seated in the battery housing

cavity.

5. Snap the two halves back together.

2004 Econoline (eco)

Owners Guide (post-2002-fmt)

USA English (fus)

Locks and Security

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 255 256

Pas de commentaire

Ford 2004 E-450 v.3 Manuel d'utilisateur Page 77