Ford 2003 E-550 v.1 Manuel d'utilisateur télécharger pdf (Page 134)

Preparing to tow

Use the proper equipment for towing a trailer and make sure it is

properly attached to your vehicle. See your dealer or a reliable trailer

dealer if you require assistance.

Hitches

Do not use or install hitches that clamp onto the bumper or to the axle.

Underbody hitches are acceptable if installed properly.

Safety chains

Always connect the trailer’s safety chains to the frame or hook retainers

of the vehicle hitch. To connect the trailer’s safety chains, cross the

chains under the trailer tongue and allow slack for turning corners.

If you use a rental trailer, follow the instructions that the rental agency

gives to you.

Do not attach safety chains to the bumper.

Trailer brakes

Electric brakes and manual, automatic or surge-type trailer brakes are

safe if installed properly and adjusted to the manufacturer’s

specifications. The trailer brakes must meet local and Federal

regulations.

Do not connect a trailer’s hydraulic brake system directly to your

vehicle’s brake system. Your vehicle may not have enough

braking power and your chances of having a collision greatly increase.

The braking system of the tow vehicle is rated for operation at the

GVWR not GCWR.

Trailer lamps

Trailer lamps are required on most towed vehicles. Make sure your

trailer lamps conform to local and Federal regulations. See your dealer or

trailer rental agency for proper instructions and equipment for hooking

up trailer lamps.

Using a step bumper (if equipped)

The rear bumper is equipped with an integral hitch and only requires a

ball with a 25.4 mm (one inch) shank diameter. The bumper has a 2,270

kg (5,000 lb.) trailer weight and 227 kg (500 lb.) tongue weight capacity.

Driving

134

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 231 232

Pas de commentaire

Ford 2003 E-550 v.1 Manuel d'utilisateur Page 134