Ford 2000 Ranger Manuel d'utilisateur télécharger pdf (Page 79)

The lap belts should fit snugly and as low as possible around the

hips, not around the waist.

If you need to lengthen the belt, unfasten it and repeat the procedure

above.

To unfasten the belt, push in the release button prior to opening the rear

door.

Safety belt extension assembly

If the safety belt assembly is too short, even when fully extended, 20 cm

(8 inches) can be added to the safety belt assembly by adding a safety

belt extension assembly (part number 611C22). Safety belt extension

assemblies can be obtained from your dealer at no cost.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended. Do not use extensions to change the

fit of the shoulder belt across the torso.

Safety belt warning light and indicator chime

The seat belt warning light illuminates in the instrument cluster and a

chime sounds to remind the occupants to fasten their safety belts.

Conditions of operation

If... Then...

The driver’s safety belt is not

buckled before the ignition switch

is turned to the ON position...

The safety belt warning light

illuminates1-2 minutes and the

warning chime sounds 4-8

seconds.

The driver’s safety belt is buckled

while the indicator light is

illuminated and the warning chime

is sounding...

The safety belt warning light and

warning chime turn off.

The driver’s safety belt is buckled

before the ignition switch is turned

to the ON position...

The safety belt warning light and

indicator chime remain off.

Seating and safety restraints

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 239 240

Pas de commentaire

Ford 2000 Ranger Manuel d'utilisateur Page 79