Ford 2000 Ranger Manuel d'utilisateur télécharger pdf (Page 201)

Replacing high-mount brakelamp and cargo lamp bulbs

The replacement of the high-mount brakelamp bulb and cargo lamp bulb

is basically the same. This procedure covers the high-mount brakelamp

bulb.

To remove the brakelamp assembly:

1. Remove the two screws and lamp

assembly from vehicle.

2. Remove the bulb socket from

lamp assembly by rotating it

counterclockwise.

3. Carefully pull bulb straight out of

socket and push in the new bulb.

To install the brakelamp assembly:

1. Install the bulb socket into the

lamp assembly by rotating

clockwise.

2. Install the lamp assembly on the vehicle and secure with two screws.

Replacing license plate lamp bulbs

The license plate bulbs are located

behind the rear bumper. To change

the license plate lamp bulbs:

1. Reach behind the rear bumper to

locate the bulb socket.

2. Twist the socket counterclockwise

and remove.

3. Pull out the old bulb from socket

and push in the new bulb.

4. Install the bulb socket in lamp

assembly by turning it clockwise.

Using the right bulbs

Replacement bulbs are specified in the chart below. Headlamp bulbs must

be marked with an authorized “D.O.T.” for North America and an “E” for

Europe to assure lamp performance, light brightness and pattern and safe

visibility. The correct bulbs will not damage the lamp assembly or void the

lamp assembly warranty and will provide quality bulb burn time.

Maintenance and care

201

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 239 240

Pas de commentaire

Ford 2000 Ranger Manuel d'utilisateur Page 201