Ford 2000 Ranger Manuel d'utilisateur télécharger pdf (Page 99)

Attaching safety seats with tether straps

Some manufacturers make safety seats that include a tether strap that

goes over the back of the vehicle seat and attaches to an anchoring

point. Other manufacturers offer the tether strap as an accessory.

Contact the manufacturer of your child safety seat for information about

ordering a tether strap.

In Super Cabs equipped with Center Facing Jump Seats, the tether strap

anchor bracket should be installed only at the center of the cab’s back

panel with the child seat in the front center seating position. Installing

an anchor bracket at the right rear of the cab may increase risk of injury

to an occupant of the right rear center facing jump seat in the event of a

collision or a sudden stop. If a tether child seat is installed in the right

front seating position, secure the tether strap to the webbing of the

buckled right rear lap belt.

You can attach a tether strap anchor bracket to the cab inner back panel

by using a tether anchor kit (613D20) available at no charge from any

Ford dealer.

Do not install a child seat in a center facing jump seat.

Tether anchorage hardware

Tether anchorage hardware kits (part number 613D20) including

instructions, may be obtained at no charge from any Ford or

Lincoln-Mercury dealer.

Tighten the anchor according to specifications. Otherwise, the

safety seat may not be properly secured and the child may be

injured in a sudden stop or collision.

Seating and safety restraints

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 239 240

Pas de commentaire

Ford 2000 Ranger Manuel d'utilisateur Page 99