Ford 2010 F-150 v.1 Manuel d'utilisateur télécharger pdf (Page 290)

100

101

If the fuse is not blown and the brakelamps are working properly, the

following procedure will allow you to move the gearshift lever from P

(Park):

1. Apply the parking brake, turn the

ignition key to the off position, and

remove the key.

2. Starting at the rear of the trim

panel, using a screwdriver (or

similar tool) carefully pry up the

trim panel from rear attachments

and disconnect it from the console

to expose the inside of the gearshift.

3. Locate the brake shift interlock

lever on the passenger side of the

shifter assembly.

4. Apply the brake pedal. Using a

screwdriver (or similar tool), press

and hold the brake shift interlock

lever while pulling the gearshift

lever out of the P (Park) position

and into the N (Neutral) position.

5. Install the trim panel.

6. Apply brake pedal, start the vehicle, and release the parking brake.

See your authorized dealer as soon as possible if this procedure

is used.

WARNING: Do not drive your vehicle until you verify that the

brakelamps are working.

WARNING: Always set the parking brake fully and make sure

the gearshift is latched in P (Park). Turn the ignition to the off

position and remove the key whenever you leave your vehicle.

WARNING: If the parking brake is fully released, but the brake

warning lamp remains illuminated, the brakes may not be

working properly. See your authorized dealer.

Driving

290

2010 F-150 (f12)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 418 419

Commentaires sur ces manuels

Pas de commentaire

Ford 2010 F-150 v.1 Manuel d'utilisateur Page 290

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2010 F-150 v.1