Ford 2010 F-150 v.1 Manuel d'utilisateur télécharger pdf (Page 129)

Deactivating/activating autounlock feature

Your vehicle comes with the autounlock features activated; there are four

methods to enable/disable this feature:

• Through your authorized dealer,

• by using a power door unlock/lock sequence,

• using a keypad procedure (if equipped), or

• or by using the instrument cluster message center (if equipped). Refer

to Message center in the Instrument ClusterDriver Controls chapter.

Note: The autounlock feature can be activated/deactivated

independently of the autolock feature.

Power door lock switch autounlock enable/disable procedure

Before starting, ensure the ignition is in the off position and all vehicle

doors are closed. You must complete Steps 1–5 within 30 seconds or the

procedure will have to be repeated. If the procedure needs to be

repeated, wait a minimum of 30 seconds before beginning again.

1. Place the key in the ignition and

turn the ignition to the on position.

2. Press the power door unlock

control three times.

3. Turn the ignition from the on

position to the off position.

4. Press the power door unlock

control three times.

5. Turn the ignition back to the on position. The horn will chirp one time

to confirm programming mode has been entered and is active.

6. To enable/disable the autounlock feature, press the lock control, then

press the unlock control. The horn will chirp once if autounlock was

deactivated or twice (one short and one long chirp) if autounlock was

activated.

7. Turn the ignition to the off position. The horn will chirp once to

confirm the procedure is complete.

Keyless entry keypad autounlock enable/disable procedure

1. Turn the ignition to the off position.

2. Close all the doors.

3. Enter factory–set 5–digit entry code.

Locks and Security

129

2010 F-150 (f12)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 418 419

Pas de commentaire

Ford 2010 F-150 v.1 Manuel d'utilisateur Page 129