Ford 2014 Mustang v.3 Manuel d'utilisateur télécharger pdf (Page 146)

100

101

Reprogramming a single button

To program a device to a previously trained button, follow these steps:

1. Press and hold the desired button. Do NOT release the button.

2. The indicator light will begin to flash after 20 seconds. Without

releasing the button, follow Step 1 in the Programming section.

For questions or comments, contact HomeLink® at www.homelink.com

or 1-800-355-3515.

Programming HomeLink to a Genie Intellicode 2 garage door

opener

Note: The Genie Intellicode 2 transmitter must already be programmed

to operate with the garage door opener.

Programing the transmitters

To program HomeLink to the transmitter you must first put the

transmitter into programming mode. To do this:

A. Red LED

B. Green LED

1. Press and hold one of the buttons on the hand-held transmitter for

10 seconds. The LED light will change from green to green and red.

2. Press the same button twice to confirm the change to Programming

mode. If done properly the LED light will appear red.

3. Hold the transmitter within 1–3 inches (2–8 centimeters) of the

button on the sun visor you want to program.

4. Press and hold both the programmed Genie button on the hand-held

transmitter and the button on the sun visor you want to program. The

indicator light on the sun visor will flash rapidly when the programming

is successful.

Universal Garage Door Opener (If Equipped) 145

2014 05+ Mustang (197)

Owners Guide gf, 3rd Printing, January 2014

USA (fus)

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 462 463

Commentaires sur ces manuels

Pas de commentaire

Ford 2014 Mustang v.3 Manuel d'utilisateur Page 146

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2014 Mustang v.3