Ford 2008 Mustang v.2 Manuel d'utilisateur télécharger pdf (Page 95)

driver door key cylinder, the system will monitor the doors,

trunk, and hood but the motion sensing and vehicle incline

sensing will not arm.

Do not arm the interior motion detection system if movement within the

vehicle is likely to occur. Additionally, do not arm the vehicle incline

sensing system when the vehicle is in transport.

For proper operation of the interior motion detection system, ensure all

windows are closed prior to arming the system. This will help prevent

accidental alarm activation due to external influences and ensure proper

interior motion detection. Additionally, the interior motion sensing

system will not arm if either door or the trunk is ajar.

If there is any potential active anti-theft problem with your vehicle,

ensure ALL remote entry transmitters are taken to an authorized

dealer to aid in troubleshooting.

Arming the system

When armed, the active anti-theft system is designed to notify you of an

unauthorized entry. When unauthorized entry or towing occurs, the

system will flash the turn signal lamps and interior lamps and sounds the

security horn.

The system is ready to arm whenever the key is out of the ignition. Any

of the following actions will arm the alarm system:

• Press the remote transmitter lock control one time to arm the system.

• Lock all doors using the interior power lock switch while the driver or

passenger door is open and then becomes closed.

• Lock the driver door with the key in the key lock cylinder (this will

not however arm the interior motion or vehicle incline sensing

systems or lock the passenger door).

If all the closures (doors, trunk, hood) are closed, the turn signal lamps

will flash once. If any closure is not properly closed the parklamps will

not flash. Note: Locking the driver door with the key does not lock the

passenger door. Use the power door lock control or manually lock the

passenger door to ensure the vehicle is properly secured.

The system will wait 20 seconds after locking before triggering an alarm.

After the 20–second pre-arm phase, the power door unlock control is

disabled (for more information, refer to Power door trim switch inhibit

section earlier in this chapter) to further protect your vehicle.

2008 05+ Mustang (197)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 287 288

Pas de commentaire

Ford 2008 Mustang v.2 Manuel d'utilisateur Page 95