Ford 2008 Mustang v.2 Manuel d'utilisateur télécharger pdf (Page 211)

2. If the air pressure reads 19 psi (131 kPa) or higher, switch the air

compressor on by pressing the “I” side of the orange button and adjust

the air pressure to the recommended pressure. This pressure can be

found on a label affixed to the B-Pillar or the edge of the driver’s door. If

the air pressure is higher than the label states, reduce the excess

pressure by pressing down on the pressure release valve (8).

Note: Before driving any further, adjust the tire pressure to the

recommended pressure on the vehicle’s tire placard located on the

B-pillar inside the driver’s door.

3. Turn the air compressor off by pressing the “O” side of the orange

button, then unscrew the hose from the tire’s air valve, reinstall the tire

valve cap, unplug the electrical plug from the power point and stow the

temporary mobility kit in its original location.

What to do after the tire has been sealed

After using the temporary mobility kit to seal your tire, you will need to

replace the sealing compound and hose. Sealing compound and spare

parts can be obtained and replaced at an authorized dealer or tire dealer.

Empty sealing compound bottles may be disposed of at home; however,

liquid residue from the sealing compound should be disposed by your

authorized dealer or tire dealer, or in accordance with local waste

disposal regulations.

Note: After the sealing compound has been used, the maximum vehicle

speed is 50 mph (80 km/h) and the maximum driving distance is 120

miles (200 km). The sealed tire should be replaced immediately, or at

least within the 120 miles (200 km). After sealant use, the TPMS (Tire

Pressure Monitoring Sensor) located inside the wheel, must be replaced

by an authorized Ford dealer.

Note: If you experience any unusual vibration, ride disturbance or noise

while driving, reduce your speed until you can safely pull off to the side

of the road to call for roadside assistance.

You can check the tire pressure any time within the 120 miles (200 km)

by performing the following:

1. Ensure the compressor is turned off by pressing the “O” side of the

orange button.

2. Remove the hose and the cable with the electrical plug from the kit’s

storage compartment.

3. Remove the valve cap from the sealed tire, then screw the hose firmly

onto the tire’s air valve.

2008 05+ Mustang (197)

Owners Guide (post-2002-fmt)

USA (fus)

Roadside Emergencies

211

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 287 288

Commentaires sur ces manuels

Pas de commentaire

Ford 2008 Mustang v.2 Manuel d'utilisateur Page 211

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2008 Mustang v.2