Ford 2008 Explorer v.3 Manuel d'utilisateur télécharger pdf (Page 142)

2. Press and hold the RESET

control for more than 2 seconds. Oil

life is set to 100% and “OIL

CHANGE SET TO 100%” is

displayed.

Note: To change oil life 100% miles

value from 7,500 miles (12,070 km)

or 6 months to another value,

proceed to step 3.

3. Once “OIL LIFE SET TO XXX%”

is displayed, release and press the

RESET control switch to change the

Oil Life Start Value. Each release

and press will reduce the value by

10 percent.

Note: Oil Life Start Value of 100%

equals 7,500 miles (12,070 km) or 6

months. For example, setting Oil Life Start Value to 60% sets the Oil Life

Start Value to 3,000 miles (4,828 km) and 120 days.

System warnings

System warnings alert you to possible problems or malfunctions in your

vehicle’s operating systems.

In the event of a multiple warning situation, the message center will

cycle the display to show all warnings by displaying each one for 4

seconds.

The message center will display the last selected feature if there are no

more warning messages. This allows you to use the full functionality of

the message center after you acknowledge the warning by pressing the

RESET control and clearing the warning message.

Warning messages are divided into four categories:

• They cannot be cleared until the condition is corrected.

• They will reappear on the display ten minutes from the reset if the

condition has not been corrected.

• They will not reappear until an ignition OFF-ON cycle has been

completed.

• They reappear if the condition clears then reoccurs within the same

ignition ON-OFF cycle.

This acts as a reminder that these warning conditions still exist within

the vehicle.

Driver Controls

142

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 399 400

Pas de commentaire

Ford 2008 Explorer v.3 Manuel d'utilisateur Page 142