Ford 2008 Explorer v.3 Manuel d'utilisateur télécharger pdf (Page 152)

• Through your authorized dealer, or

• Performing the power door lock control procedure, or

• Performing the keyless entry key pad (if equipped) procedure, or

• Performing the message center (if equipped) procedure.

Note: The autolock feature can be activated/deactivated independently

of the autounlock feature.

Before following the activation or deactivation procedures, make sure

that the anti-theft system is not armed, ignition is in the 1 (OFF/LOCK)

position and all vehicle doors, liftgate and liftgate window are closed.

Power door unlock/lock procedure

You must complete Steps 1-5 within

30 seconds or the procedure will

have to be repeated. If the

procedure needs to be repeated,

you must wait 30 seconds. Note:

All doors must be closed and

remain closed throughout the

configuration process.

1. Turn the ignition to the 3 (ON) position.

2. Press the power door unlock control three times.

3. Turn the ignition from the 3 (ON) to the 1 (OFF/LOCK) position.

4. Press the power door unlock control three times.

5. Turn the ignition back to the 3 (ON) position. The horn will chirp.

6. Press the unlock control, then press the lock control. The horn will

chirp once if autolock was deactivated or twice (one short and one long

chirp) if autolock was activated.

7. Turn the ignition to the 1 (OFF/LOCK) position. The horn will chirp

once to confirm the procedure is complete.

Keyless entry key pad procedure

1. Turn the ignition to the 1 (OFF/LOCK) position.

2. Close all doors, the liftgate and liftgate window.

3. Enter 5–digit entry code

4. Press and hold the 3 • 4. While holding the 3 • 4 press the 7 • 8.

5. Release the 7 • 8.

6. Release the 3 • 4.

Locks and Security

152

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 399 400

Pas de commentaire

Ford 2008 Explorer v.3 Manuel d'utilisateur Page 152