Ford 2007 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 90)

100

101

3. At the back of the headlamp,

remove the two headlamp assembly

retainer bolts.

4. Slide headlamp assembly forward

and off the retaining tab to expose

the back of the headlamp assembly.

5. Rotate the bulb socket

counterclockwise and remove from

the lamp assembly.

6. Carefully pull the bulb out of the

socket and push in the new bulb.

7. Install the bulb socket into the

lamp assembly and rotate clockwise.

8. Install the headlamp assembly

and secure with two retainer bolts.

Replacing tail/stop/turn/sidemarker/backup lamp bulbs

The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same

portion of the tail lamp assembly, one just below the other. Follow the

same steps to replace either bulb:

1. Make sure the headlamp switch is

in the OFF position and then open

the liftgate to expose the lamp

assembly screws.

2. Remove the two torx screws from

the lamp assembly.

3. Carefully remove the lamp

assembly away from the vehicle by

pulling the assembly straight out to

expose the bulb socket. DO NOT

TIP THE LAMP ASSEMBLY SIDEWAYS.

4. Rotate the bulb socket counterclockwise and remove from lamp

assembly.

5. Pull bulb straight out of socket and snap in the new bulb.

2007 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 375 376

Commentaires sur ces manuels

Pas de commentaire

Ford 2007 Expedition v.2 Manuel d'utilisateur Page 90

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2007 Expedition v.2