Ford 2007 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 275)

Utility and four-wheel drive vehicles are not designed for

cornering at speeds as high as passenger cars any more than

low-slung sports cars are designed to perform satisfactorily under

off-road conditions. Avoid sharp turns or abrupt maneuvers in these

vehicles.

Note: The Control Trac selector knob should not be changed while the

rear wheels are slipping.

Shifting between modes

Shifting from 2H to 4A or 4H

Move the control to the 4A or 4H position at any forward speed up to

55 mph (88 km/h) or at a stop. The message center may display “4X4

SHIFT IN PROGRESS” during the system shift. The RTT location in the

message center will then display “4X4 AUTO” if 4A is selected or “4X4” if

4H is selected.

Shifting from 4A to 4H

Move the control from 4A to 4H at a stop or while driving at any speed.

The RTT location in the message center will display “4X4”.

Shifting to/from 4L

1. Bring the vehicle to a stop.

2. Place the gearshift in N (Neutral).

3. Move the control to the desired position.

The message center will display “4X4 SHIFT IN PROGRESS” during the

shift. The RTT location in the message center will then display the

system mode selected.

If any of the above shift conditions are not met, the shift will not occur

and the RTT location in the message center will display the appropriate

information.

Note: Some noise may be heard as the system shifts or engages.

Driving off-road with truck and utility vehicles

Four–wheel drive vehicles are specially equipped for driving on sand,

snow, mud and rough terrain and have operating characteristics that are

somewhat different from conventional vehicles, both on and off the road.

2007 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Driving

275

1 2 ... 270 271 272 273 274 275 276 277 278 279 280 ... 375 376

Pas de commentaire

Ford 2007 Expedition v.2 Manuel d'utilisateur Page 275