Ford 2005 Taurus v.3 Manuel d'utilisateur télécharger pdf (Page 37)

To install the new bulb:

Handle a halogen headlamp bulb carefully and keep out of

children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to

break the next time the headlamps are operated.

1. Install the new bulb in lamp assembly by pushing straight in with the

flat surface of the bulb’s plastic base facing upward. You may need to

turn the bulb slightly to align the grooves in the plastic base with the

tabs in the lamp assembly.

2. Install the bulb retaining ring over the plastic base and lock the ring

by rotating clockwise until it snaps into place.

3. Connect the electrical connector to the bulb.

4. Install the protective dust shield and lock the shield by rotating it

clockwise until it locks into position.

5. Carefully position the headlamp assembly onto the vehicle.

6. Hold the headlamp assembly snugly against the vehicle and install the

retainer pins straight down to lock the lamp into place.

7. Before reinstalling the bolt, make sure the retainer pins are fully

seated, and install bolt on headlamp housing.

8. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

2005 Taurus (tau)

Owners Guide (post-2002-fmt)

USA (fus)

Lights

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 255 256

Pas de commentaire

Ford 2005 Taurus v.3 Manuel d'utilisateur Page 37