Ford 2005 Taurus v.1 Manuel d'utilisateur télécharger pdf (Page 58)

Erasing HomeLinkT buttons

To erase the three programmed

buttons (individual buttons cannot

be erased):

• Press and hold the two outer

HomeLinkt buttons until the

indicator light begins to

flash-after 20 seconds. Release

both buttons. Do not hold for

longer that 30 seconds.

HomeLinkt is now in the train (or

learning) mode and can be programmed at any time beginning with step

2inthe“Programming” section.

Reprogramming a single HomeLink

button

To program a device to HomeLinkt using a HomeLinkt button previously

trained, follow these steps:

1. Press and hold the desired HomeLinkt button. Do NOT release the

button.

2. The indicator light will begin to flash after 20 seconds. Without

releasing the HomeLinkt button, follow step 2 in the “Programming”

section.

For questions or comments, contact HomeLinkt at www.homelink.com

or 1–800–355–3515.

MESSAGE CENTER

With the ignition in the ON position,

the message center, located on your

instrument cluster, displays

important vehicle information

through a constant monitor of

vehicle systems. You may select

display features on the message center for a display of status preceded

by a brief indicator chime. The system will also notify you of potential

vehicle problems with a display of system warnings followed by a long

indicator chime.

Driver Controls

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 247 248

Pas de commentaire

Ford 2005 Taurus v.1 Manuel d'utilisateur Page 58