Ford 2005 Expedition v.3 Manuel d'utilisateur télécharger pdf (Page 333)

concentration testing is possible with a hydrometer or antifreeze tester

(such as the Rotunda Battery and Antifreeze Tester, 014–R1060). The

level of coolant should be maintained at the “FULL COLD” level or

within the “COLD FILL RANGE” in the coolant reservoir. If the level falls

below, add coolant per the instructions in the Adding engine coolant

section.

Your vehicle was factory-filled with a 50/50 engine coolant and water

concentration. If the concentration of coolant falls below 40% or above

60%, the engine parts could become damaged or not work properly. A

50–50 mixture of coolant and water provides the following:

• Freeze protection down to -34°F (-36°C).

• Boiling protection up to 265°F (129°C).

• Protection against rust and other forms of corrosion.

• Enables calibrated gauges to work properly.

When the engine is cold, check the

level of the engine coolant in the

reservoir.

• The engine coolant should be at the “FULL COLD” level or within the

“COLD FILL RANGE” as listed on the engine coolant reservoir

(depending upon application).

• Refer to scheduled maintenance information for service interval

schedules.

• Be sure to read and understand Precautions when servicing your

vehicle in this chapter.

If the engine coolant has not been checked at the recommended interval,

the engine coolant reservoir may become low or empty. If the reservoir is

2005 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

333

1 2 ... 328 329 330 331 332 333 334 335 336 337 338 ... 375 376

Pas de commentaire

Ford 2005 Expedition v.3 Manuel d'utilisateur Page 333