Ford 2004 Ranger v.1 Manuel d'utilisateur télécharger pdf (Page 52)

4. Evenly push down on the

extender and push the round knobs

in on each side locking it in place.

Green markings on the shaft

indicate the locked position. The

locking clip screws below the middle

bar can be tightened

counterclockwise for extra security.

Note: If the red marking on the

shaft is visible, the bed extender

is not locked or properly secured.

To stow the bed extender, follow steps one through four in reverse order.

The bed extender may be used to secure a load of up to 46 kg (100 lbs.)

on the tailgate.

The bed extender should always be kept in the stowed position

with the tailgate closed when not in use.

When driving the vehicle off road, the bed extender should be

removed and the tailgate closed.

To remove the bed extender:

1. Extend the bed extender.

2. Pull the round knobs on each side

of the extender to unlock it.

Make sure the locking clip screws

are loose before removing the

extender.

3. Press the locking clips below the

middle bar on each side and lift the

extender out of the bed.

Note: Remove and store the bed extender when not in use.

To install the bed extender, follow the removal procedure in reverse

order.

2004 Ranger (ran)

Owners Guide (post-2002-fmt)

USA English (fus)

Driver Controls

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 247 248

Pas de commentaire

Ford 2004 Ranger v.1 Manuel d'utilisateur Page 52