Ford 2003 Excursion v.1 Manuel d'utilisateur télécharger pdf (Page 151)

Note: Adjusting an equalizing hitch so the rear bumper of the vehicle is

higher than it was unloaded will defeat the function of the load

equalizing hitch and may cause unpredictable handling.

Safety chains

Always connect the trailer’s safety chains to the frame or hook retainers

of the vehicle hitch. To connect the trailer’s safety chains, cross the

chains under the trailer tongue and allow slack for turning corners.

If you use a rental trailer, follow the instructions that the rental agency

gives to you.

Do not attach safety chains to the bumper.

Trailer brakes

Electric brakes and manual, automatic or surge-type trailer brakes are

safe if installed properly and adjusted to the manufacturer’s

specifications. The trailer brakes must meet local and Federal

regulations.

Do not connect a trailer’s hydraulic brake system directly to your

vehicle’s brake system. Your vehicle may not have enough

braking power and your chances of having a collision greatly increase.

The braking system of the tow vehicle is rated for operation at the

GVWR not GCWR.

Trailer lamps

Trailer lamps are required on most towed vehicles. Make sure your

trailer lamps conform to local and Federal regulations. See your dealer or

trailer rental agency for proper instructions and equipment for hooking

up trailer lamps.

Using a step bumper (if equipped)

The rear bumper is equipped with an integral hitch and only requires a

ball with a 25.4 mm (one inch) shank diameter. The bumper has a 2,270 kg

(5,000 lb.) trailer weight and 227 kg (500 lb.) tongue weight capacity.

If it is necessary to relocate the trailer hitch ball position, a

frame-mounted trailer hitch must be installed.

Driving

151

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 239 240

Pas de commentaire

Ford 2003 Excursion v.1 Manuel d'utilisateur Page 151