Ford 2003 Excursion v.1 Manuel d'utilisateur télécharger pdf (Page 107)

Deactivating/activating the BeltMinder feature

Read steps1-9thoroughly before proceeding with the

deactivation/activation programming procedure.

The BeltMinder feature can be deactivated/activated by performing the

following procedure:

Before following the procedure, make sure that:

• The parking brake is set

• The gearshift is in P (Park) (automatic transmission)

• The ignition switch is in the OFF position

• All vehicle doors are closed

• The driver’s safety belt is unbuckled

• The parklamps/headlamps are in OFF position (If vehicle is equipped

with Autolamps, this will not affect the procedure.)

To reduce the risk of injury, do not deactivate/activate the Belt

Minder feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1–2

minutes)

• Steps 3–5 must be completed within 60 seconds or the procedure will

have to be repeated.

3. Buckle then unbuckle the safety belt three times, ending with the

safety belt unbuckled. This can be done before or during BeltMinder

warning activation.

4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.

5. Buckle then unbuckle the safety belt three times, ending with the

safety belt unbuckled.

• After step 5 the safety belt warning light will be turned on for three

seconds.

6. Within seven seconds of the safety belt warning light turning off,

buckle then unbuckle the safety belt.

• This will disable BeltMinder if it is currently enabled, or enable

BeltMinder if it is currently disabled.

7. Confirmation of disabling BeltMinder is provided by flashing the safety

belt warning light four times per second for three seconds.

Seating and Safety Restraints

107

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 239 240

Pas de commentaire

Ford 2003 Excursion v.1 Manuel d'utilisateur Page 107