Ford 2001 Taurus Manuel d'utilisateur télécharger pdf (Page 93)

The front and rear outboard safety restraints in the vehicle are

combination lap and shoulder belts. The front passenger and rear seat

outboard safety belts have two types of locking modes described below:

Energy management retractors

Your vehicle has a seat belt system equipped with energy management

retractors at the driver and front outboard passenger seating positions.

An energy management retractor is a device which pays out webbing in a

controlled manner. This feature is designed to help further reduce the

risk of force-related injuries to the occupant.

Seat belt systems equipped with an energy management retractor must

be replaced if they were in use during a frontal collision which resulted

in deployment of the frontal air bags. Refer to the Safety belt

maintenance section in this chapter.

In the event of a collision resulting in the deployment of the

front air bags, the front safety belts must be replaced if they

were in use.

After any vehicle collision, the seat belt system at all outboard

seating positions (except driver, which has no “automatic locking

retractor” feature) must be checked by a qualified technician to verify

that the “automatic locking retractor” feature for child seats is still

functioning properly. In addition, all seat belts should be checked for

proper function.

BELT AND RETRACTOR ASSEMBLY MUST BE REPLACED if

the seat belt assembly “automatic locking retractor” feature or

any other seat belt function is not operating properly when checked

according to the procedures in Workshop Manual.

Failure to replace the Belt and Retractor assembly could

increase the risk of injury in collisions.

Seating and safety restraints

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 255 256

Pas de commentaire

Ford 2001 Taurus Manuel d'utilisateur Page 93