Ford 2001 Mustang Manuel d'utilisateur télécharger pdf (Page 87)

Safety belt maintenance

Inspect the safety belt systems periodically to make

sure they work properly and are not damaged.

Inspect the safety belts to make sure there are no

nicks, tears or cuts. Replace if necessary. All safety

belt assemblies, including retractors, buckles, front

seat belt buckle assemblies, buckle support

assemblies (slide bar-if equipped), shoulder belt

height adjusters (if equipped), shoulder belt guide

on seatback (if equipped), child safety seat tether

bracket assemblies (if equipped), LATCH child seat

tether anchors and lower anchors (if equipped), and

attaching hardware, should be inspected after a

collision. Ford recommends that all safety belt

assemblies used in vehicles involved in a collision be

replaced. However, if the collision was minor and a

qualified technician finds that the belts do not show

damage and continue to operate properly, they do

not need to be replaced. Safety belt assemblies not

in use during a collision should also be inspected

and replaced if either damage or improper operation

is noted.

Failure to inspect and if necessary replace

the safety belt assembly under the above

conditions could result in severe personal injuries

in the event of a collision.

Refer to Cleaning and maintaining the safety

belts in the Maintenacne and Care section.

Seating and safety restraints

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 239 240

Pas de commentaire

Ford 2001 Mustang Manuel d'utilisateur Page 87