Ford 2005 Ranger v.1 Manuel d'utilisateur télécharger pdf (Page 109)

6. Install the spare tire lock (if equipped) into the access hole above the

rear bumper with the spare tire lock key (if equipped) and jack handle.

WHEEL LUG NUT TORQUE SPECIFICATIONS

Retighten the lug nuts to the specified torque at 50–100 miles (80–160

km) after any wheel disturbance (rotation, flat tire, wheel removal, etc.).

Lug nut socket

size/Bolt size

Wheel lug nut torque*

lb.ft. N•m

Lug nut socket size:

⁄

” (19 mm) hex

Bolt size:

⁄

x20

100 135

* Torque specifications are for nut and bolt threads free of dirt and

rust. Use only Ford recommended replacement fasteners.

When a wheel is installed, always remove any corrosion, dirt and

foreign materials present on the mounting surfaces of the wheel

and the surface of the front disc brake hub and rotor that contacts the

wheel. Installing wheels without correct metal-to-metal contact at the

wheel mounting surfaces can cause the wheel nuts to loosen and the

wheel to come off while the vehicle is in motion, resulting in loss of

control.

Note: If there is corrosion on the area where the wheel contacts the

hub, apply a thin film of grease or anti-seize compound on that area.

INFORMATION CONTAINED ON THE TIRE SIDEWALL

Federal law requires tire manufacturers to place standardized

information on the sidewall of all tires. This information identifies and

describes the fundamental characteristics of the tire and also provides a

U.S. DOT Tire Identification Number for safety standard certification and

in case of a recall.

REVIEW COPY

2005 Ranger (ran), Owners Guide (post-2002-fmt) (own2002),

Market: USA_English (fus)

Tires, Wheels and Loading

109

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 255 256

Pas de commentaire

Ford 2005 Ranger v.1 Manuel d'utilisateur Page 109