Ford 2013 Explorer v.2 Manuel d'utilisateur télécharger pdf (Page 85)

100

101

Programming a Spare Intelligent Access Keys (if equipped)

Note: A maximum of four intelligent access keys can be programmed to

your vehicle. You must take your vehicle and all access keys to your

authorized dealer to be erased and reprogrammed if you would like to

replace a previously programmed access key with a new access key, or if

you already have four access keys programmed to your vehicle.

You must have two previously programmed intelligent access keys inside

the vehicle and the new unprogrammed intelligent access keys readily

accessible. See your authorized dealer to have the spare key

programmed if two previously programmed keys are not available.

Make sure that the vehicle is off before beginning this procedure. Make

sure that all doors are closed before beginning and that they remain

closed throughout the procedure. Perform all steps within 30 seconds of

starting the sequence. Stop and wait for at least one minute before

starting again if any steps are performed out of sequence.

Read and understand the entire procedure before you begin.

1. Place the new unprogrammed

intelligent access key, with the

buttons facing out, in the pocket

inside of the center console.

2. Press the driver or passenger

power door unlock control three

times.

3. Press and release the brake pedal

one time.

4. Press the driver or passenger power door lock control three times.

5. Press and release the brake pedal one time. The indicator on the

START/STOP button should begin to rapidly flash, indicating the

programming mode has been entered and two programmed intelligent

access keys have been detected in the vehicle.

6. Press the START/STOP button within one minute. A message will

appear in the information display indicating that the new intelligent

access key was programmed.

7. Remove the intelligent access key from the center console pocket and

press the unlock button on the newly programmed intelligent access key

to exit programming mode.

8. Verify that the remote entry functions operate (press lock then

unlock, making sure you end in unlock) and that the vehicle starts with

new intelligent access key.

Security 85

2013 Explorer (exp)

Owners Guide gf, 2nd Printing

USA (fus)

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 564 565

Commentaires sur ces manuels

Pas de commentaire

Ford 2013 Explorer v.2 Manuel d'utilisateur Page 85

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2013 Explorer v.2