Ford 2013 Escape v.4 Manuel d'utilisateur télécharger pdf (Page 64)

2. Press the 1·2 on the keypad within five

seconds.

3. Enter your personal 5-digit code. You

must enter each number within five

seconds of each other.

4. The doors will lock then unlock to

confirm that programming is complete.

Tips:

• Do not set a code that uses five of the

same number.

• Do not use five numbers in sequential

order.

• The factory-set code will work even if

you have set your own personal code.

Erasing a Personal Code

1. Enter the factory-set 5-digit code.

2. Press and release the 1·2 on the keypad

within five seconds.

3. Press and hold the 1·2 for two seconds.

This must be done within five seconds

of completing Step 2.

All personal codes will erase and only the

factory-set 5–digit code will work.

Anti-Scan Feature

The keypad will go into an anti-scan mode

if you enter the wrong code seven times

(35 consecutive button presses). This

mode disables the keypad for one minute

and the keypad lamp will flash.

The anti-scan feature will turn off after:

• one minute of keypad inactivity

• pressing the unlock button on the

remote control

• switching the ignition on

• unlocking the vehicle using intelligent

access

Unlocking and Locking the Doors

To Unlock the Driver Door

Enter the factory-set 5-digit code or your

personal code. You must press each

number within five seconds of each other.

The interior lamps will illuminate.

Note: All doors will unlock if the two-stage

unlocking feature is disabled. See Locking

and Unlocking (page 53).

To Unlock All Doors

Enter the factory-set code or your personal

code, then press the 3·4 control within five

seconds.

To Lock All Doors

Press and hold 7·8 and 9·0 at the same

time with the driver door closed. You do

not need to enter the keypad code first.

60

Esca

p

e

(

TM2

)

Locks

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 221 222

Commentaires sur ces manuels

Pas de commentaire