Ford 2013 Escape v.4 Manuel d'utilisateur télécharger pdf (Page 63)

Setting the Liftgate Open Height

1. Open the liftgate.

2. Manually move the liftgate to the

desired height.

3. Press and hold the control button on

the liftgate until you hear a chime,

indicating programming is complete.

Note: You cannot program the height if the

liftgate position is too low.

The new open liftgate height will now be

recalled when the power liftgate is opened.

To change the programmed height, repeat

the above procedure. Once you open the

power liftgate, you can manually move it

to a different height.

When operating the power liftgate after

you have programmed a lower height than

full-open, you can fully open the liftgate

by manually pushing it upward to the

maximum open position.

Obstacle Detection

When Closing

The system stops when it detects an

obstacle and two short tones sound. Once

you remove the obstacle, you can power

close the liftgate.

Note: Entering the vehicle while the liftgate

is closing can cause the vehicle to bounce

and activate obstacle detection. To prevent

this, allow the power liftgate to fully close

before entering the vehicle. Before driving

off, check the instrument cluster for a

liftgate or door ajar message or warning

indicator. Driving off without first checking

for the liftgate or door ajar message or

warning indicator could result in the liftgate

being left open, unintentionally, while you

are driving.

When Opening

The system stops when it detects an

obstacle and two short tones sound.

Remove the obstacle to operate the

liftgate.

KEYLESS ENTRY (IF EQUIPPED)

SECURICODE™ KEYLESS ENTRY

KEYPAD

(

You can use the keypad to:

• lock or unlock the doors

• program and erase user codes

• arm and disarm the anti-theft alarm.

You can operate the keypad with the

factory-set 5-digit entry code. The code is

located on the owner’s wallet card in the

glove box and is available from your

authorized dealer. You can also create up

to five of your own 5-digit personal entry

codes.

Programming a Personal Entry Code

To create your own personal entry code:

1. Enter the factory-set code.

59

Esca

p

e

(

TM2

)

Locks

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 221 222

Commentaires sur ces manuels

Pas de commentaire