Ford 2012 Fiesta v.3 Manuel d'utilisateur télécharger pdf (Page 233)

STARTING

Positions of the ignition

If your vehicle is equipped with a push button start system, refer to

Push button start system in this section for ignition modes.

1. 0 (off) — locks the steering

wheel, automatic transmission

gearshift lever and allows key

removal. This position also shuts the

engine and all electrical accessories

off.

2. I (accessory) — allows the electrical accessories such as the radio to

operate while the engine is not running.

3. II (on) — all electrical circuits operational. Warning lights illuminated.

Key position when driving.

4. III (start) — cranks the engine. Release the key as soon as the engine

starts.

Note: Do not store the key in the ignition after the vehicle is turned off

and you have left the vehicle. This could cause a drain on the battery.

Preparing to start your vehicle

Engine starting is controlled by the powertrain control system.

This system meets all Canadian interference-causing equipment standard

requirements regulating the impulse electrical field strength of radio

noise.

When starting a fuel-injected engine, don’t press the accelerator before

or during starting. Only use the accelerator when you have difficulty

starting the engine. For more information on starting the vehicle, refer to

Starting the engine in this chapter.

WARNING: Extended idling at high engine speeds can produce

very high temperatures in the engine and exhaust system,

creating the risk of fire or other damage.

WARNING: Do not park, idle, or drive your vehicle in dry grass

or other dry ground cover. The emission system heats up the

engine compartment and exhaust system, which can start a fire.

Driving

233

2012 Fiesta (fie)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 359 360

Pas de commentaire

Ford 2012 Fiesta v.3 Manuel d'utilisateur Page 233