Ford 2010 Transit Connect v.2 Manuel d'utilisateur télécharger pdf (Page 240)

4. Place the gearshift lever in P (Park) and leave the engine running.

5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If

necessary, refer to Identifying components in the engine compartment

in this chapter for the location of the dipstick.

6. Install the dipstick making sure it is fully seated in the filler tube.

7. Remove the dipstick and inspect the fluid level. The fluid should be in

the designated areas for normal operating temperature.

Low fluid level

Do not drive the vehicle if the fluid

level is at the bottom of the

dipstick. If the fluid level is below

the MIN mark, add fluid in 1/2 pint

(250 ml) increments.

Correct fluid level

The transmission fluid should be checked at normal operating

temperatures 120°F-140°F (50°C-60°C) on a level surface. The normal

operating temperature can be reached after approximately 20 miles

(30 km) of driving.

The transmission fluid should be in

this range if at normal operating

temperature (120°F-140°F

[50°C-60°C]).

High fluid level

Fluid levels above the safe range

may result in transmission failure.

An overfill condition of transmission

fluid may cause shift and/or

engagement concerns and/or

possible damage.

High fluid levels can be caused by an overheating condition.

Adjusting automatic transmission fluid levels

Before adding any fluid, make sure the correct type is used. The type of

fluid used is normally indicated on the dipstick and also in the

Maintenance product specifications and capacities section in this

chapter.

Maintenance and Specifications

240

2010 Transit Connect (tst)

Owners Guide (own2002), 2nd Printing

USA (fus)

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 258 259

Pas de commentaire

Ford 2010 Transit Connect v.2 Manuel d'utilisateur Page 240