Ford 2010 Transit Connect v.2 Manuel d'utilisateur télécharger pdf (Page 113)

Your vehicle has LATCH lower anchors for child seat installation at the

seating positions marked with the child seat symbol.

The LATCH anchors are located at

the rear section of the rear seat

between the cushion and seatback,

below the locator symbols on the

seat back. Follow the child seat

manufacturer’s instructions to

properly install a child seat with

LATCH attachments.

Follow the instructions on attaching

child safety seats with tether straps.

Refer to Attaching child safety

seats with tether straps later in this

chapter.

Attach LATCH lower attachments of

the child seat only to the anchors

shown.

WARNING: Never attach

two child safety seats to the

same anchor. In a crash, one

anchor may not be strong enough

to hold two child safety seat

attachments and may break,

causing serious injury or death.

WARNING: Depending on where you secure a child restraint,

and depending on the child restraint design, you may block

access to certain safety belt buckle assemblies and/or LATCH lower

anchors, rendering those features potentially unusable. To avoid risk of

injury, occupants should only use seating positions where they are able

to be properly restrained.

If you install a child seat with rigid LATCH attachments, and have

attached the top tether strap to the proper top tether anchor, do not

tighten the tether strap enough to lift the child seat off the vehicle seat

cushion when the child is seated in it. Keep the tether strap just snug

without lifting the front of the child seat. Keeping the child seat just

touching the vehicle seat gives the best protection in a severe crash.

Seating and Safety Restraints

113

2010 Transit Connect (tst)

Owners Guide (own2002), 2nd Printing

USA (fus)

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 258 259

Pas de commentaire

Ford 2010 Transit Connect v.2 Manuel d'utilisateur Page 113