Ford 2010 Explorer v.1 Manuel d'utilisateur télécharger pdf (Page 143)

100

101

Note: The Car2U威 system allows for three devices to be programmed. If

you need to change or replace any of the three devices after it has been

initially programmed, it is necessary to erase the current settings using

the Erasing the Car2U威 Home Automation System buttons procedure

and then programming all of the devices being used.

Fixed code programming

Note: Do not program the Car2U威 system with the vehicle in the garage.

Make sure that your key is on and engine off while programming the

transmitter.

1. To program units with fixed code DIP switches, you will need the

garage door hand-held transmitter, paper and a pen or pencil.

2. Open the battery cover and record the switch settings from left to

right for all 8 to 12 switches. Use the figure below:

When a switch is in the up, on, or + position, circle “L.”

When a switch is in the middle, neutral, or 0 position, circle “M.”

When a switch is in the down, off, or – position, circle “R.”

Switch

position 12345678 9101112

Up, on

or +

LLLLLLLLLLLL

Middle,

neutral

or 0

MMMMMMMMMMMM

Down,

offor–

RRRRRRRRRRRR

L=left; M=middle; R=right

Driver Controls

143

2010 Explorer (exp)

Owners Guide (own2002), 1st Printing

USA (fus)

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 403 404

Commentaires sur ces manuels

Pas de commentaire

Ford 2010 Explorer v.1 Manuel d'utilisateur Page 143

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2010 Explorer v.1