Ford 2010 Explorer Sport Trac Manuel d'utilisateur télécharger pdf (Page 167)

Installing child safety seats with combination lap and shoulder

belts

If needed, when installing some high back child restraints, the head

restraints of the second row seating positions can be removed. Insert a

thin pointed object, such as a paper clip or pushpin, into the hole of

each head restraint guide and while lifting up remove the head restraint.

Store the head restraint in a secure location in the vehicle, such as on

the floor against the rear of the front seats. To re-install the head

restraint, line the posts up in the holes on the seat back with the head

restraint strap facing the outside of the vehicle and push down until the

head restraint locks into place. Lift gently to ensure it is locked into

place.

WARNING: If the head restraint has been removed from a

seating position to accommodate a high back child restraint, the

head restraint must be re-installed prior to use of the seat by any other

occupant in order to reduce the risk of personal injury in the event of

a collision.

Check to make sure the child seat is properly secured before each use.

Children 12 and under should be properly restrained in a rear seating

position whenever possible. If all children cannot be seated and

restrained properly in a rear seating position, properly restrain the

largest child in the front seat.

When installing a child safety seat with combination lap/shoulder belts:

• Use the correct safety belt buckle for that seating position.

• Insert the belt tongue into the proper buckle until you hear a snap

and feel it latch. Make sure the tongue is securely fastened in the

buckle.

Seating and Safety Restraints

167

2010 07+ Explorer Sport Trac (esp)

Owners Guide (own2002), 1st Printing

USA (fus)

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 343 344

Pas de commentaire

Ford 2010 Explorer Sport Trac Manuel d'utilisateur Page 167