Ford 2010 Expedition v.1 Manuel d'utilisateur télécharger pdf (Page 146)

Programming

Do not program HomeLink威 with the vehicle parked in the garage.

Note: Your vehicle may require the ignition switch to be turned to the

accessory position for programming and/or operation of the HomeLink威.

It is also recommended that a new battery be placed in the hand-held

transmitter of the device being programmed to HomeLink威 for quicker

training and accurate transmission of the radio-frequency signal.

1. Position the end of your

hand-held transmitter 1–3 inches

(2–8 cm) away from the HomeLink威

button you wish to program (located

on your visor) while keeping the

indicator light in view.

2. Simultaneously press and hold

both the chosen HomeLink威 and

hand-held transmitter buttons until the HomeLink威 indicator light

changes from a slow to a rapidly blinking light. Now you may release

both the HomeLink威 and hand-held transmitter buttons.

Note: Some entry gates and garage door openers may require you to

replace Step 2 with procedures noted in the Gate Operator and

Canadian Programming in this section for Canadian residents.

3. Firmly press and hold for five seconds and release the

programmed HomeLink威 button up to two separate times to activate the

door. If the door does not activate, press and hold the just-trained

HomeLink威 button and observe the indicator light.

• If the indicator light stays on constantly, programming is complete

and your device should activate when the HomeLink威 button is pressed

and released.

• If the indicator light blinks rapidly for two seconds and then turns

to a constant light continue with “Programming” Steps 4 through

6 to complete programming of a rolling code equipped device (most

commonly a garage door opener).

4. At the garage door opener receiver (motor-head unit) in the garage,

locate the “learn” or “smart” button (usually near where the hanging

antenna wire is attached to the unit).

5. Firmly press and release the “learn” or “smart” button. (The name and

color of the button may vary by manufacturer.)

Note: There are 30 seconds in which to initiate Step 6.

6. Return to the vehicle and firmly press, hold for two seconds and

release the programmed HomeLink威 button. Repeat the

Driver Controls

146

2010 Expedition (exd)

Owners Guide (own2002), 1st Printing

USA (fus)

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 419 420

Commentaires sur ces manuels

Pas de commentaire

Ford 2010 Expedition v.1 Manuel d'utilisateur Page 146

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2010 Expedition v.1