Ford 2009 Edge v.2 Manuel d'utilisateur télécharger pdf (Page 121)

6. Turn the ignition to the 1 (off) position and remove the second

previously programmed coded key from the ignition.

7. After three seconds but within 20 seconds of turning the ignition to

the 1 (off) position and removing the previously programmed coded

key, insert the new unprogrammed key (new key/valet key) into the

ignition.

8. Turn the ignition from the 1 (off) position to the 3 (on) position. Keep

the ignition in the 3 (on) position for at least six seconds.

9. Remove the newly programmed coded key from the ignition.

If the key has been successfully programmed it will start the vehicle’s

engine and will operate the remote entry system (if the new key is an

Integrated Keyhead Transmitter). The theft indicator light will illuminate

for three seconds and then go out to indicate successful programming.

If the key was not successfully programmed, it will not start your

vehicle’s engine and/or will not operate the remote entry features. The

theft indicator light may flash on and off. Wait 20 seconds and you may

repeat Steps 1 through 8. If failure repeats, bring your vehicle to your

authorized dealer to have the new key(s) programmed.

To program additional new unprogrammed key(s), wait 20 seconds and

then repeat this procedure from Step 1.

2009 Edge (edg)

Owners Guide, 2nd Printing

USA (fus)

Locks and Security

121

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 325 326

Pas de commentaire

Ford 2009 Edge v.2 Manuel d'utilisateur Page 121