Ford 2008 Taurus v.1 Manuel d'utilisateur télécharger pdf (Page 109)

2. Press and release RESET to pause the timer.

3. Press and hold RESET for 2 seconds in order to reset the timer.

Compass display

The compass heading is displayed in the lower left corner of the message

center next to the odometer.

The compass reading may be affected when you drive near large

buildings, bridges, power lines and powerful broadcast antenna. Magnetic

or metallic objects placed in, on or near the vehicle may also affect

compass accuracy.

Usually, when something affects the compass readings, the compass will

correct itself after a few days of operating your vehicle in normal

conditions. If the compass still appears to be inaccurate, a manual

calibration may be necessary. Refer to Compass zone/calibration

adjustment.

Most geographic areas (zones) have a magnetic north compass point that

varies slightly from the northerly direction on maps. This variation is four

degrees between adjacent zones and will become noticeable as the

vehicle crosses multiple zones. A correct zone setting will eliminate this

error. Refer to Compass zone/calibration adjustment.

Compass zone adjustment

Perform the following steps on an open area free from steel structures

and high voltage lines. For optimum calibration, turn off all electrical

accessories (heater / air conditioning, wipers, etc.) and make sure all

vehicle doors are shut.

1. Turn ignition to the ON position.

2. Start the engine.

3. Determine your magnetic zone by

referring to the zone map.

123

6 7 8 9 1011

2008 Taurus (tau)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

109

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 319 320

Pas de commentaire

Ford 2008 Taurus v.1 Manuel d'utilisateur Page 109