Ford 2008 Mustang v.1 Manuel d'utilisateur télécharger pdf (Page 86)

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed

because you lost one, or would like to buy additional remote entry

transmitters, you can either reprogram them yourself, or take all

remote entry transmitters to your authorized dealer for

reprogramming.

How to reprogram your remote entry transmitters

You must have all remote entry transmitters (maximum of six)

available before beginning this procedure.

Note: Ensure the brake pedal is not

depressed during this sequence.

To reprogram the remote entry

transmitters:

1. Ensure the vehicle is

electronically unlocked.

2. Put the key in the ignition.

3. Cycle eight times rapidly (within

10 seconds) between the 1

(OFF/LOCK) position and 3 (ON).

Note: The eighth turn must end in the 3 (ON) position. The doors will

lock, then unlock, to confirm that the programming mode has been

activated.

4. Within 20 seconds press any button on the remote entry transmitter.

Note: If more than 20 seconds have passed you will need to start the

procedure over again. The doors will lock, then unlock, to confirm that

this remote entry transmitter has been programmed.

5. Repeat Step 4 to program each additional remote entry transmitter.

6. Turn the ignition to the 1 (OFF/LOCK) position after you have

finished programming all of the remote entry transmitters. Note: After

20 seconds, you will automatically exit the programming mode. The

doors will lock, then unlock, to confirm that the programming mode has

been exited.

2008 05+ Mustang (197)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 279 280

Pas de commentaire

Ford 2008 Mustang v.1 Manuel d'utilisateur Page 86