Ford 2003 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 224)

Changing the air filter element

1. Release the clamps that secure the air filter housing cover.

2. Carefully separate the two halves of the air filter housing.

3. Remove the air filter element from the air filter housing.

4. Wipe the air filter housing and cover clean to remove any dirt or

debris and to ensure good sealing.

5. Install a new air filter element. Be

careful not to crimp the filter

element edges between the air filter

housing and cover. This could cause

filter damage and allow unfiltered

air to enter the engine if not

properly seated.

6. Replace the air filter housing cover and secure the clamps.

7. Replace the air inlet tube and secure the clamp.

Note: Failure to use the correct air filter element may result in severe

engine damage. The customer warranty may be voided for any damage to

the engine if the correct air filter element is not used.

INFORMATION ABOUT UNIFORM TIRE QUALITY GRADING

New vehicles are fitted with tires

that have a rating on them called

Tire Quality Grades. The Quality

grades can be found where

applicable on the tire sidewall

between tread shoulder and

maximum section width. For

example:

• Treadwear 200 Traction AA Temperature A

These Tire Quality Grades are determined by standards that the United

States Department of Transportation has set.

Tire Quality Grades apply to new pneumatic tires for use on passenger

cars. They do not apply to deep tread, winter-type snow tires,

space-saver or temporary use spare tires, tires with nominal rim

diameters of 10 to 12 inches or limited production tires as defined in

Title 49 Code of Federal Regulations Part 575.104(c)(2).

Maintenance and Specifications

224

1 2 ... 219 220 221 222 223 224 225 226 227 228 229 ... 247 248

Pas de commentaire

Ford 2003 Crown Victoria v.2 Manuel d'utilisateur Page 224