Ford 2003 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 220)

CHECKING AND ADDING POWER STEERING FLUID

Check the power steering fluid.

Refer to the scheduled maintenance

guide for the service interval

schedules. If adding fluid is

necessary, use only MERCONt ATF.

1. Start the engine and let it run until it reaches normal operating

temperature (the engine coolant temperature gauge indicator will be

near the center of the normal area between H and C).

2. While the engine idles, turn the steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the

reservoir. It should be between the

MIN and MAX lines. Do not add

fluid if the level is in this range.

5. If the fluid is low, add fluid in small amounts, continuously checking

the level until it reaches the range between the MIN and MAX lines. Be

sure to put the cap back on the reservoir.

BRAKE FLUID RESERVOIR

The fluid level will drop slowly as

the brakes wear, and will rise when

the brake components are replaced.

Fluid levels below the “MAX” line

that do not trigger the brake system

warning lamp are within the normal

operating range, there is no need to

MAX

MIN

MAX

Maintenance and Specifications

220

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 247 248

Pas de commentaire

Ford 2003 Crown Victoria v.2 Manuel d'utilisateur Page 220