Ford 2003 Crown Victoria v.2 Manuel d'utilisateur télécharger pdf (Page 140)

5. Clip the tether strap to the

anchor as shown.

If the tether strap is clipped

incorrectly, the child safety

seat may not be retained properly

in the event of a collision.

6. Refer to the Installing child safety seats with combination lap and

shoulder belts section of this chapter for further instructions to secure

the child safety seat.

7. Tighten the child safety seat tether strap according to the

manufacturer’s instructions.

If the safety seat is not anchored properly, the risk of a child

being injured in a collision greatly increases.

Attaching safety seats with LATCH (Lower Anchors and Tethers for

Children) attachments

Some child safety seats have two rigid or webbing mounted attachments

that connect to two anchors at certain seating positions in your vehicle.

This type of child seat eliminates the need to use seat belts to attach the

child seat. For forward-facing child seats, the tether strap must also be

attached to the proper tether anchor. See Attaching safety seats with

tether straps in this chapter.

Your vehicle has LATCH anchors for child seat installation at the seating

positions marked with the child seat symbol.

The anchors on both sides of the

center of the rear seat are provided

for child seats at the outboard seats,

and are further apart than the pairs

of lower anchors for child seat

installation at other seats. DO NOT

install child seats with LATCH

attachments (rigid or mounted on

belt webbing) to the lower anchors

at the center rear seat. If you install a child seat at the center rear

position, use the vehicle belt and the top tether anchor.

Seating and Safety Restraints

140

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 247 248

Pas de commentaire

Ford 2003 Crown Victoria v.2 Manuel d'utilisateur Page 140