Ford 2003 Crown Victoria v.1 Manuel d'utilisateur télécharger pdf (Page 57)

WINDSHIELD WIPER/WASHER CONTROLS

Rotate the windshield wiper control

to the desired interval, low or high

speed position.

The bars of varying length are for

intermittent wipers. When in this

position rotate the control upward

for fast intervals and downward for

slow intervals.

Push the end of the stalk to activate

washer. Push and hold for a longer

wash cycle.

Windshield wiper/washer features

The exterior lamps will illuminate after 10–20 second delay when the

ignition is ON and the windshield wiper control is in the interval, LO or

HI position.

The lights will remain on for 30 seconds after the wipers are turned off.

Checking the wiper blades

If the wiper blades do not wipe properly, clean both the windshield and

wiper blades using undiluted windshield wiper solution or a mild

detergent. Rinse thoroughly with clean water. To avoid damaging the

blades, do not use fuel, kerosene, paint thinner or other solvents.

Changing the wiper blades

To make changing the wiper blades easy, turn the ignition to ACC, then

turn the wipers on. When the wipers reach the vertical position, turn the

ignition to LOCK.

To replace the wiper blades:

Driver Controls

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 231 232

Pas de commentaire

Ford 2003 Crown Victoria v.1 Manuel d'utilisateur Page 57