Ford 2001 Explorer Sport Trac Manuel d'utilisateur télécharger pdf (Page 222)

1. With the flat side of the new bulb’s plastic base facing upward, insert

the glass end of the bulb into the lamp assembly. Turn the bulb left or

right to align the grooves in the plastic base with the tabs in the lamp

assembly. When the grooves are aligned, push the bulb into the lamp

assembly until the plastic base contacts the rear of the lamp assembly.

2. Install the bulb retaining ring over the plastic base until it contacts the

rear of the socket by rotating it clockwise until you feel a “stop.”

3. Connect the electrical connector into the rear of the plastic base until

it snaps, locking it into position.

4. Install the headlamp on vehicle by aligning the lamp on the vehicle,

push rearward and secure with two retainer pins.

5. Install the protective cover over headlamps locking it in place.

6. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal bulbs

1. Remove screw from the lamp

assembly.

2. Disengage lamp assembly.

3. Rotate bulb socket

counterclockwise and remove from

lamp assembly.

4. Carefully pull bulb straight out of

socket and push in the new bulb.

5. Install bulb socket in lamp

assembly by turning clockwise.

6. Align the parking lamp assembly

and push to snap in place.

7. Install screw on lamp assembly.

Maintenance and care

222

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 263 264

Pas de commentaire

Ford 2001 Explorer Sport Trac Manuel d'utilisateur Page 222