Ford 2000 Excursion v.1 Manuel d'utilisateur télécharger pdf (Page 195)

Replacing headlamp bulbs

1. Make sure that the headlamp control is in the OFF position.

2. Open the hood.

3. Disconnect the electrical

connector from the bulb by pulling

rearward.

4. Remove bulb retainer ring by

turning it counterclockwise about

⁄

turn, then slide the ring off the

plastic base.

5. Without turning, carefully pull

bulb out of headlamp assembly.

Handle a halogen headlamp bulb carefully and keep out of

children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to

break the next time the headlamps are operated.

6. Insert the glass end of the new bulb into the headlamp assembly.

When the grooves in the plastic base are aligned, push the bulb into the

lamp assembly until the plastic base contacts the rear of the lamp

assembly.

7. Install bulb retaining ring over the plastic base and lock the ring into

the socket by turning it clockwise until you feel a “stop.”

8. Connect the electrical connector into the rear of the plastic base until

it “snaps.”

Replacing front parking/turn signal bulbs

1. Make sure headlamp switch is in OFF position.

2. Open the hood.

Maintenance and care

195

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 231 232

Pas de commentaire

Ford 2000 Excursion v.1 Manuel d'utilisateur Page 195