Ford 2012 Focus v.1 Manuel d'utilisateur télécharger pdf (Page 189)

How to disengage the automatic locking mode

Disconnect the combination lap/shoulder belt and allow it to retract

completely to disengage the automatic locking mode and activate the

vehicle sensitive (emergency) locking mode.

WARNING: After any vehicle collision, the safety belt system at

all passenger seating positions must be checked by an authorized

dealer to verify that the “automatic locking retractor” feature for child

seats is still functioning properly. In addition, all safety belts should be

checked for proper function.

WARNING: BELT AND RETRACTOR ASSEMBLY MUST BE

REPLACED if the safety belt assembly “automatic locking

retractor” feature or any other safety belt function is not operating

properly when checked by an authorized dealer. Failure to replace the

belt and retractor assembly could increase the risk of injury in

collisions.

Safety belt extension assembly

If the safety belt is too short when fully extended, an 8 inch (20 cm)

front safety belt or 9 inch (23 cm) rear safety belt extension assembly

can be added (part numbers 3S4Z-54611C22 and 6F22-16611C22

respectively). These assemblies can be obtained from an authorized

dealer.

Use only extensions manufactured by the same supplier as the safety

belt. Manufacturer identification is located at the end of the webbing on

the label. Also, use the safety belt extension only if the safety belt is too

short for you when fully extended.

WARNING: Do not use extensions to change the fit of the

shoulder belt across the torso.

Seating and Safety Restraints

189

2012 Focus (foc)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 405 406

Pas de commentaire

Ford 2012 Focus v.1 Manuel d'utilisateur Page 189