Ford 2007 Escape Hybrid Manuel d'utilisateur télécharger pdf (Page 296)

If this is the first check of the

transmission fluid, it may be

necessary to remove the perforated

section of the splash shield (as

indicated on the splash shield).

6. Be sure the engine has been stopped for at least 3 minutes before

performing the fluid level check.

7. The fluid level should be within

1/4 inch (6 mm) of the plug threads.

8. Replace the check plug.

Adjusting eCVT fluid levels

Before adding any fluid, make sure the correct type is used. The type of

fluid used is indicated in the Maintenance product specifications and

capacities section in this chapter.

Use of a non-approved fluid may cause internal transaxle

component damage.

If the fluid level is low, add fluid through the check port until the level is

correct and fluid begins to run out of the transmission. If an overfill

occurs, excess fluid should be removed by allowing the fluid to run out

of the check port.

A serious overfill condition of transmission fluid may cause

damage.

Do not use supplemental transmission fluid additives, treatments or

cleaning agents. The use of these materials may affect transmission

operation and result in damage to internal transmission components.

2007 Escape Hybrid (ehv)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

296

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 335 336

Pas de commentaire

Ford 2007 Escape Hybrid Manuel d'utilisateur Page 296