Ford 2001 Excursion v.2 Manuel d'utilisateur télécharger pdf (Page 78)

Programming remote transmitters

It is necessary to have all (maximum of four — original and/or new) of

your remote transmitters available prior to beginning this procedure.

To program the transmitters yourself:

• Place the key in the ignition and

turn from 2 (LOCK) to 3 (OFF)

and cycle between 3 (OFF) and

4(ON) eight times in rapid

succession (within 10 seconds)

with the eighth turn ending in the

4 (ON) position. The doors will

lock/unlock to confirm that

programming mode has been

entered.

• Within 20 seconds, program a

remote transmitter by pressing any button on a transmitter. The doors

will lock/unlock to confirm that the remote transmitter has been

programmed. (If more than 20 seconds pass before pressing a remote

transmitter button, the programming mode will exit and the procedure

will have to be repeated.)

• Repeat the previous step to program additional remote transmitters.

The doors will lock/unlock to confirm that each remote transmitter has

been programmed.

• When you have completed programming the remote transmitters, turn

the ignition to 3 (OFF). Again the doors will lock/unlock to confirm

programming has been completed.

Keyless entry system

With the keyless entry keypad, you can:

• lock or unlock the vehicle doors without using the key.

Your vehicle has a factory set 5 digit code that operates the keyless entry

system. You can also program your own 5 digit personal entry code. The

factory-set code is located:

• on the owner’s wallet card in the glove compartment

When pressing the controls on the keyless entry keypad, press the

middle of the controls to ensure a good activation.

Controls and features

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 247 248

Pas de commentaire

Ford 2001 Excursion v.2 Manuel d'utilisateur Page 78