Ford 2001 Excursion v.2 Manuel d'utilisateur télécharger pdf (Page 142)

Do not exceed the GVWR or the GAWR specified on the

certification label.

Towing trailers beyond the maximum recommended gross trailer

weight could result in engine damage, transmission/axle damage,

structural damage, loss of control, and personal injury.

Preparing to tow

Use the proper equipment for towing a trailer, and make sure it is

properly attached to your vehicle. See your dealer or a reliable trailer

dealer if you require assistance.

Load equalizing hitch

When hooking up a trailer using a load equalizing hitch, always use the

following procedure:

1. Park the unloaded vehicle on a level surface. With the ignition on and

all doors closed, allow the vehicle to stand for several minutes so that it

can level.

2. Measure the height of a reference point on the front and rear bumpers

at the center of the vehicle.

3. Attach the trailer to the vehicle and adjust the hitch equalizers so that

the front bumper height is within 0–13 mm (0.5 in) of the reference

point. After proper adjustment, the rear bumper should be no higher

than in Step 3.

Adjusting an equalizing hitch so the rear bumper of the vehicle

is lower or higher than it was unloaded will defeat the function

of the load equalizing hitch and may cause unpredictable handling.

Safety chains

Always connect the trailer’s safety chains to the frame or hook retainers

of the vehicle hitch. To connect the trailer’s safety chains, cross the

chains under the trailer tongue and allow slack for turning corners.

If you use a rental trailer, follow the instructions that the rental agency

gives to you.

Do not attach safety chains to the bumper.

Driving

142

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 247 248

Pas de commentaire

Ford 2001 Excursion v.2 Manuel d'utilisateur Page 142