Ford 2014 F-150 Raptor v.3 Manuel d'utilisateur télécharger pdf (Page 294)

Tire Change Procedure

WARNINGS

When one of the front wheels is off

the ground, the transmission alone

will not prevent the vehicle from

moving or slipping off the jack, even if the

transmission selector lever is in position P.

To help prevent the vehicle from

moving when you change a tire, be

sure to place the transmission

selector lever in position P, set the parking

brake and block (in both directions) the

wheel that is diagonally opposite (other

side and end of the vehicle) to the tire

being changed.

Never get underneath a vehicle that

is supported only by a jack. If the

vehicle slips off the jack, you or

someone else could be seriously injured.

Do not attempt to change a tire on

the side of the vehicle close to

moving traffic. Pull far enough off the

road to avoid the danger of being hit when

operating the jack or changing the wheel.

Always use the jack provided as

original equipment with your vehicle.

If using a jack other than the one

provided as original equipment with your

vehicle, make sure the jack capacity is

adequate for the vehicle weight, including

any vehicle cargo or modifications.

Disable the power running boards

before jacking, lifting, or placing any

object under the vehicle. Never place

your hand between the power running

board and the vehicle as extended power

running boards will retract when the doors

are closed. Failure to follow these

instructions may result in personal injury.

Note: Passengers should not remain in the

vehicle when the vehicle is being jacked.

Park on a level surface, activate the hazard

flashers and set the parking brake. Then,

place the transmission selector lever in

position P and turn the engine off.

To remove the jack on Regular Cab and

SuperCab models:

Remove the wing nut and turn the jack

screw counterclockwise to release

pressure before removing the jack from the

bracket.

To remove the jack on SuperCrew

models:

1. Lift both rear seat cushions.

2. Remove the insert containing the Easy

Fuel funnel from the driver's side.

3. Remove the two small wing nuts on

the passenger side.

4. Slide the plastic box toward the driver's

side and remove.

See the instruction sheet (located with the

jack) for detailed tire change instructions.

Removing the spare tire

E166715

1. Use the ignition key to remove the lock

cylinder from the access hole of the

bumper to allow access to the guide

tube. Assemble the jack handle as

shown in the illustration.

291

F150 (TF6) , enUSA

Wheels and Tires

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 471 472

Commentaires sur ces manuels

Pas de commentaire