Ford 2014 F-150 Raptor v.3 Manuel d'utilisateur télécharger pdf (Page 279)

Tire Label (affixed to either the

door hinge pillar, door-latch post,

or the door edge that meets the

door-latch post, next to the

driver's seating position), or Tire

Label located on the B-pillar or

the edge of the driver's door.

Failure to follow the tire pressure

recommendations can cause

uneven treadwear patterns and

adversely affect the way your

vehicle handles

Note: Do not reduce tire pressure

to change the ride characteristics

of the vehicle. If you do not

maintain the inflation pressure at

the levels specified by Ford, your

vehicle may experience a condition

known as shimmy. Shimmy is a

severe vibration and oscillation in

the steering wheel after the vehicle

travels over a bump or dip in the

road that does not dampen out by

itself. Shimmy may result from

significant under-inflation of the

tires, improper tires (load range,

size, or type), or vehicle

modifications such as lift-kits. In

the event that your vehicle

experiences shimmy, you should

slowly reduce speed by either lifting

off the accelerator pedal or lightly

applying the brakes. The shimmy

will cease as the vehicle speed

decreases.

Maximum Inflation Pressure is

the tire manufacturer's maximum

permissible pressure and the

pressure at which the maximum

load can be carried by the tire. This

pressure is normally higher than

the manufacturer’s recommended

cold inflation pressure which can

be found on the Safety

Compliance Certification Label

(affixed to either the door hinge

pillar, door-latch post, or the door

edge that meets the door-latch

post, next to the driver's seating

position), or Tire Label located on

the B-pillar or the edge of the

driver's door. The cold inflation

pressure should never be set lower

than the recommended pressure

on the Safety Compliance

Certification Label or Tire Label.

When weather temperature

changes occur, tire inflation

pressures also change. A 10°F

(6°C) temperature drop can

cause a corresponding drop of 1

psi (7 kPa) in inflation pressure.

Check your tire pressures

frequently and adjust them to the

proper pressure which can be

found on the Safety Compliance

Certification Label or Tire Label.

To check the pressure in your

tire(s):

1. Make sure the tires are cool,

meaning they are not hot from

driving even a mile.

276

F150 (TF6) , enUSA

Wheels and Tires

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 471 472

Commentaires sur ces manuels

Pas de commentaire