Ford 2014 F-150 Raptor v.3 Manuel d'utilisateur télécharger pdf (Page 133)

4. Press and hold both the programmed

Genie button on the hand-held

transmitter and the button you want

to program. The indicator light on the

visor will flash rapidly when the

programming is successful.

Note: The Genie transmitter will transmit

for up to 30 seconds. If HomeLink does not

program within 30 seconds you will need to

press the Genie transmitter again. If the

Genie transmitter indicator light displays

green and red, release the button until the

indicator light turns off before pressing the

button again.

Once you have programmed HomeLink

successfully, you must change the Genie

transmitter out of program mode. To do

this:

1. Press and hold the previously

programmed Genie button on the

hand-held transmitter for 10 seconds.

The indicator light will change from red

to red and green.

2. Press the same button twice to confirm

the change. If done correctly the

indicator light will turn green.

Programming HomeLink to the Genie

Intellicode Garage Door Opener Motor

Note: You may need a ladder to access the

garage door opener motor.

E142662

1. Press and hold the program button on

the garage door opener motor until

both blue indicator lights turn on.

2. Release the program button. Only the

smaller round indicator light should be

on.

3. Press and release the program button.

The larger purple indicator light will

flash.

Note: The next two steps must be

completed in 30 seconds.

4. Press and release the previously

programmed button on the Genie

Intellicode 2 hand-held transmitter.

Both indicator lights on the garage door

opener motor unit should now flash

purple.

5. Press and hold the previously

programmed button on the visor for

two seconds. Repeat this step up to

three times until the garage door

moves.

Programming is now complete.

Clearing a HomeLink Device

To erase programming from the three

HomeLink buttons press and hold the two

outer HomeLink buttons until the indicator

light begins to flash. The indicator light will

begin flashing in 10-20 seconds. When this

happens, release both buttons. You have

now erased the programming, and the

indicator light should blink slowly to

indicate the device is in train mode when

you press any of the three HomeLink

buttons.

130

F150 (TF6) , enUSA

Universal Garage Door Opener (If Equipped)

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 471 472

Commentaires sur ces manuels

Pas de commentaire