Ford 2014 F-150 Raptor v.3 Manuel d'utilisateur télécharger pdf (Page 244)

Only use oils certified for gasoline engines

by the American Petroleum Institute (API).

An oil with this trademark symbol

conforms to the current engine and

emission system protection standards and

fuel economy requirements of the

International Lubricants Specification

Advisory Council (ILSAC), comprised of

U.S. and Japanese automobile

manufacturers.

1. Check the engine oil level.

2. If the engine oil level is not within the

normal range, add engine oil that

meets Ford specifications. See

Capacities and Specifications (page

296).

3. Remove the engine oil filler cap and

use a funnel to pour the engine oil into

the opening.

4. Recheck the engine oil level. Make sure

the oil level is not above the normal

operating range on the engine oil level

dipstick.

5. Install the engine oil level dipstick and

ensure it is fully seated.

6. Fully install the engine oil filler cap by

turning the filler cap clockwise until

three clicks are heard or until the cap

is fully seated.

ENGINE COOLANT CHECK

WARNINGS

Do not add engine coolant when the

engine is hot. Steam and scalding

liquids released from a hot cooling

system can burn you badly. Also, spilling

coolant on hot engine parts can burn you.

Do not put engine coolant in the

windshield washer fluid container. If

sprayed on the windshield, engine

coolant could make it difficult to see

through the windshield.

WARNINGS

To reduce the risk of personal injury,

make sure the engine is cool before

unscrewing the coolant pressure

relief cap. The cooling system is under

pressure. steam and hot liquid can come

out forcefully when you loosen the cap

slightly.

Do not add coolant further than the

MAX mark.

Checking the Engine Coolant

When the engine is cold, check the

concentration and level of the engine

coolant at the intervals listed in the

scheduled maintenance information. See

Scheduled Maintenance (page 438).

Note: Make sure that the coolant level is

between the MIN and MAX marks on the

coolant reservoir.

Note: Coolant expands when it is hot. The

level may extend beyond the MAX mark.

Note: If the level is at the MIN mark, below

the MIN mark, or empty, add coolant

immediately. See Adding Engine Coolant

in this chapter.

Maintain coolant concentration within

48% to 50%, which equates to a freeze

point between -30°F (-34°C) and -34°F

(-37°C).

Note: For best results, coolant

concentration should be tested with a

refractometer such as Rotunda tool

300-ROB75240 available from your

authorized dealer. Ford does not

recommend the use of hydrometers or

coolant test strips for measuring coolant

concentrations.

Note: Automotive fluids are not

interchangeable. Do not use engine coolant,

antifreeze or windshield washer fluid outside

of its specified function and vehicle location.

241

F150 (TF6) , enUSA

Maintenance

1 2 ... 239 240 241 242 243 244 245 246 247 248 249 ... 471 472

Commentaires sur ces manuels

Pas de commentaire